Search
Now showing items 1-10 of 22
Discussion: “Application of Energy Model of Turbulence to Calculation of Lubricant Flows” (Ho, Mein-Kai, and Vohr, J. H., 1974, ASME J. Lubr. Technol., 96, pp. 95–102)
Publisher: The American Society of Mechanical Engineers (ASME)
The Prandtl-Kolmogorov Model of Turbulence With the Inclusion of Second-Order Terms
Publisher: The American Society of Mechanical Engineers (ASME)
Discussion: “A Reynolds Stress Model for Turbulent Corner Flows—Parts I and II” (Gessner, F. B., Emery, A. F., and Po, J. K., 1976, ASME J. Fluids Eng., 98, pp. 261–276)
Publisher: The American Society of Mechanical Engineers (ASME)
Laminarization of the Turbulent Boundary Layer in a Severe Acceleration
Publisher: The American Society of Mechanical Engineers (ASME)
Parametric and Numerical Study of Fully Developed Flow and Heat Transfer in Rotating Rectangular Ducts
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: This work is concerned with fully developed constant-density turbulent flow through rectangular straight ducts rotating in an orthogonal mode. Ducts of both square and 2:1 aspect ratio cross ...
Sensitizing the Dissipation Equation to Irrotational Strains
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The paper recommends the addition of an extra term to the conventional approximate transport equation for the turbulence energy dissipation rate. The term may be interpreted as emphasizing the ...
PSL—An Economical Approach to the Numerical Analysis of Near-Wall, Elliptic Flow
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: The paper points out that, in the numerical computation of elliptic or three-dimensional turbulent flows, the neglect of pressure-variations across the very thin viscosity affected region near ...
Flow in Finite-Width, Thrust Bearings Including Inertial Effects: I—Laminar Flow
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: Presented is a new numerical procedure for the calculation of flow in finite-width bearing films. The method, based on the integro-differential approach, is a development of schemes devised by ...
Developing Buoyancy-Modified Turbulent Flow in Ducts Rotating in Orthogonal Mode
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A numerical study of developing flow through a heated duct of square cross section rotating in orthogonal mode is reported. The two main aims are to explore the effects of rotational buoyancy ...
Flow in Finite-Width Thrust Bearings Including Inertial Effects: II—Turbulent Flow
Publisher: The American Society of Mechanical Engineers (ASME)
Abstract: A new set of turbulent resistance laws for hydrodynamic lubricant films has been derived with the aid of a turbulence model which includes transport effects on two turbulence parameters. The ...